Creating, configuring, and deleting vSwitches & Port Groups

Before I get started it’s important to understand that, for the most part, the information in this article applies only to VMware ESX. VMware ESXi doesn’t have a Linux-based Service Console like VMware ESX, and therefore doesn’t have a readily-accessible CLI from which to run these sorts of commands. There is a remote CLI available, which I’ll discuss in a future post, but for now I’ll focus only on VMware ESX.

The majority of all the networking configuration you will need to perform on VMware ESX boils down to just a couple commands:

• esxcfg-vswitch: You will use this command to manipulate virtual switches (vSwitches) and port groups.
• esxcfg-nics: You will use this command to view (and potentially manipulate) the physical network interface cards (NICs) in the VMware ESX host.

Configuring VMware ESX networking boils down to a couple basic tasks:

1. Creating, configuring, and deleting vSwitches
2. Creating, configuring, and deleting port groups

I’ll start with creating, configuring, and deleting vSwitches.

Creating, Configuring, and Deleting vSwitches

You’ll primarily use the esxcfg-vswitch command for the majority of these tasks. Unless I specifically indicate otherwise, all the commands, parameters, and arguments are case-sensitive.

To create a vSwitch, use this command:

esxcfg-vswitch -a <vSwitch Name>

To link a physical NIC to a vSwitch—which is necessary in order for the vSwitch to pass traffic onto the physical network or to receive traffic from the physical network—use this command:

esxcfg-vswitch -L <Physical NIC> <vSwitch Name>

In the event you don’t have information on the physical NICs, you can use this command to list the physical NICs:

esxcfg-nics -l (lowercase L)

Conversely, if you need to unlink (remove) a physical NIC from a vSwitch, use this command:

esxcfg-vswitch -U <Physical NIC> <vSwitch Name>

To change the Maximum Transmission Unit (MTU) size on a vSwitch, use this command:

esxcfg-vswitch -m <MTU size> <vSwitch Name>

To delete a vSwitch, use this command:

esxcfg-vswitch -d <vSwitch Name>

Creating, Configuring, and Deleting Port Groups

As with virtual switches, the esxcfg-vswitch is the command you will use to work with port groups. Once again, unless I specifically indicate otherwise, all the commands, parameters, and arguments are case-sensitive.

To create a port group, use this command:

esxcfg-vswitch -A <Port Group Name> <vSwitch Name>

To set the VLAN ID for a port group, use this command:

esxcfg-vswitch -v <VLAN ID> -p <Port Group Name> <vSwitch Name>

To delete a port group, use this command:

esxcfg-vswitch -D <Port Group Name> <vSwitch Name>

To view the current list of vSwitches, port groups, and uplinks, use this command:

esxcfg-vswitch -l (lowercase L)

There are more networking-related tasks that you can perform from the CLI, but for a new user these commands should handle the lion’s share of all the networking configuration. Good luck!